Begrüßungszeremonie des Displays ändern
Diese Anleitung wurde von mir getestet.
Bei GW´s mit Navi u. o.. Airbag funktioniert diese Anleitung nicht, es gibt aber eine andere Anleitung. Die Änderung bleibt auch nach dem Abklemmen der Batterie erhalten, muss aber wieder aktiviert werden.
Tipp: Die ersten 4 Eingaben müssen unmittelbar nacheinander durchgeführt werden, das Display wird sonst wieder von selbst zurückgeschaltet! Also schnell sein!
Man kann nichts kaputt machen!
Nach dem Abklemmen der Batterie und einer Wartezeit von ca. 60 Sekunden ist der Originalzustand nach dem Anklemmen der Batterie wieder hergestellt.
- Turn ignition key to ON or ACC, and wait for the normal screen display after the opening ceremony.
- Press (press and release) the MODE button three times.
- Simultaneously ‚press and hold‘ the TRIP and DISP buttons for at least 2 full seconds, and then release.
- Press the MODE button.
- Press the DISP button. You should now see the word „SPECIAL!“
If not, turn OFF the ignition key, and start all over. - Press the TRIP button.
- At the prompt „Change OK?“ press the MODE button.
- You should now see a 12-character line, with the cursor at the left end.
Use the TRIP button to cycle through the available characters until you find the one you want (letters, numbers, blank, and some others).Note: You cannot back up when cycling through the characters! If you pass the one you want, you’ll have to cycle around to the desired character again. - When the desired 12 characters have been selected, press the MODE button to store the selected characters into memory.
- Now turn the ignition key to OFF while watching the display screen. You should see the word „SEE YOU!“ with your 12-character line just underneath. When you turn the ignition key to ON or ACC, you should see „HELLO“ and your 12 character line and then a message saying „Welcome to the Gold Wing World“.